Soaked and washed the two sprue in dish washing agent, clean with old toothbrush.
Cut and cleaned nubs and ejection mold lines, followed by trial build.
Overall the fit is very good, i can see a relatively (in this kit only) "large" gap where the wing meet to the bottom of the fuselage, a little bit of filler will fix it.
There are also some flashes along side the connection area on the upper right side of fuselage and front cover / air intake area. Clean them carefully will ensure a good fit without much filler applied.
As of this point, the only fit issue which I have yet to fix is the rear vertical rudder. It does not sit in nicely to the vertical stabilier.
No comments:
Post a Comment